EN9
English
Circuit Breaker Protection
When the Circuit Breaker automatically stops the motor due to overloading, follow the below steps:
1
Switch off to reset the Circuit Breaker.
2
Unplug and disassemble the parts by reversing steps on “To Assemble” from 3-5 of page EN5 to remove
ingredients in the Head.
3
Assemble the parts again and continue grinding meat by pushing the meat slowly.
Note
:
• Circuit Breaker may not reset over 40 °C room temperature. In that case please move appliance to the room
temperature under 35 °C and wait until it is cooled down.
Troubleshooting
Please check following points before arranging for service.
Ensure to turn off the appliance and the power supply before taking the actions in the table below:
Problems
Causes
Actions
The appliance does not run after the
Switch is turned on.
The Plug is not inserted into an outlet. Insert the Plug fi rmly into an outlet.
The appliance stopped suddenly.
The Circuit Breaker Protection is
activated.
•
Prohibited ingredients are used.
•
The volume of ingredients is too
large.
• The ingredients are too hard.
See "Circuit Breaker Protection".
The Switch does not turn.
This is a malfunction.
Please contact the Service Centre for repair.
The Feed Screw is not turning even
the motor is on.
Specifi cations
Model No.
MK-GM1700
Power Supply
220 - 240 V
50 - 60 Hz
Power Consumption
240 - 290 W
Dimension (Approx.)
W × D × H
172 mm × 341 mm × 398 mm
Mass (Approx.)
4.0 k
g
Meat_Grinder_MK-GM1700.indb 9
Meat_Grinder_MK-GM1700.indb 9
6/1/2018 3:19:18 PM
6/1/2018 3:19:18 PM
