9
6. Remove all components fitted to the motor.
a. Remove the motor case plate.
b. Remove the motor support rubber (rear).
c. Remove the motor support.
d. Remove the noise suppressor.
e. Remove the motor support rubber (front).
f. Remove the lead wires connected to the motor.
4.5.
Cord reel partition unit replace-
ment
1. Increase the gap width between the cord reel and the
lower body with a screwdriver. While removing the cord
reel shaft from the side of the lower body, lift the cord reel
partition unit.
* For easy removal, pull out the cord slightly, and
then lift the cord reel.
