- 15 -
Preparation
Preparation
Attaching/Detaching the Lens
• Check that the camera is turned off.
• Change lenses where there is not a lot of dirt or dust. Refer to
when dirt or dust
gets on the lens.
• When using the interchangeable lens (H-PS14042), the lens barrel will not retract until the
power switch is turned [OFF]. Change the lens only after turning the power switch [OFF] and
checking that the lens barrel has retracted. (Do not push in the lens barrel with your fingers.
Doing so may damage the lens.)
Turn the lens rear cap
A
and the body cap
B
in the direction of the
arrow to detach them.
• Do not put your hands inside the mount.
Align the lens fitting marks
C
(red
marks) on the camera body and the lens
and then rotate the lens in the direction
of the arrow until it clicks.
• Do not press the lens release button
D
when you
attach a lens.
• Do not try to attach the lens when holding it at an
angle to the camera body as the lens mount may
get scratched.
Detach the lens cap.
Attaching a lens to the camera body
