Panasonic LP-V Series, Руководство по эксплуатации и обслуживанию

Страница: 262 / 334

262
⿎ RS-232C
This screen specifies the environmental setting of the RS-232C. To perform RS-232C communication, use the [RS-232C]
tab and set the following items:
Reference
• For communication with external devices, select either RS-232C or Ethernet port. They cannot be used at the same
time, or switched.
4
7
5 6
1 2 3
Item Description
1 Baud Rate : Specifies the baud rate.
Setting entry 1200, 2400, 4800, 9600, 19200, 38400 [bps]
Initial setting 9600 bps
2 Data Length : Indicates the data length. 8-bit fixed.
3 Parity : Specifies the parity.
Setting entry None, Odd, Even
Initial setting None
4 Stop Bits : Specifies the stop bit.
Setting entry 1bit, 2bit
Initial setting 1 bit
5 Delimit : Sets the delimiter (code to identify the end of telegraphic message).
Setting entry CR, CR+LF
Initial setting CR
6 Check Sum : Specify ON/OFF of check sum (error detection information).
Enable this function when using the check sum.
Check Sum indicates the lower 1-byte of adding result of value (binary) from the start code
to the last data by converting it to two characters for ASCII code.
7 BCS Command
GS → FNC1
: This setting is available only when the barcode “GS1 DataMatrix” is used. To set the barcode
character by using serial communication command “BCS”, select either “GS” (OFF) or “FNC1”
(ON) as the separator of AI data with the variable length.
Setting Range
ON: the separator of variable length AI data is “FNC1”.
OFF: the separator of variable length AI data is “GS”.
ME-LP400V-OP-6