Panasonic LP-V Series, Руководство по эксплуатации и обслуживанию

Страница: 170 / 334

170
4-9-5 External Offset
The external offset is the function for varying character string using I/O control by inputting coordinate data corresponding
to I/O connector No. (D0 to D15) beforehand. Refer to “Rank Offset Marking” of “External Control Manual” for control
method with I/O.
Reference
External offset function cannot be used in combination with the following functions.
• Serial Date Marking
• Equidistant marking to flying object
1
2
3
4
Description
1 Parallel Input:
Sets the input condition for the I/O connector No. (D0 to D15).
Setting Range
Not use : If you do not use the offset function, specify these values.
Low 8 bit :
Enables to set data for 256 offset values from 0 to 255 with the low 8 bit (D0
to D7) as the one marking coordinate table.
Low 4 bit :
Enables to set data for 16 offset values from 0 to 15 with the low 4 bit (D0 to
D3) as the one marking coordinate table.
2 Parallel Value (Parallel Input Value) :
Enables to check offset image of the parallel input value input beforehand. The coordinate with this parallel input
value input here displays as the coordinate for check on the image display screen.
Setting Range
In the case that the external offset condition is Low 8 bit : 0 to 255
In the case that the external offset condition is Low 4 bit : 0 to 15
3
q
Offset :
Rotates the object to the rotation direction around the original point.
Setting Range -180.00 to +180.00 degree (0.01 degree unit)
+Y
-Y
+X
-X
Rotation (+) Rotation (-)
4 X/Y Offset :
Shifts the marking position to the X/Y direction.
Setting Range
-45.000 to +45.000 mm (LP-V10)
-55.000
to
+55.000 mm (LP-430 / LP-420 / LP-410)
-80.000 to +80.000 mm (LP-435 / LP-425 / LP-V15)
-27.500
to
+27.500 mm (LP-431 / LP-421 / LP-411 / LP-W052)
ME-LP400V-OP-6