Panasonic LP-RH Series, Руководство по установке и обслуживанию, Страница: 39 / 240

39
„
Rear
1
4
7
8
9
10
11
13
2
3
15
14
6
5
16
12
1. Power connector: POWER
This is the connector for supplying the power to the head. Connect the attached unit power cable.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• For the connecting details, refer to “2-6-1 Connection of head and controller” (P.59).
2. Ethernet port: LAN
The port to connect the LAN cable used when connecting the laser marker with the following devices via Ethernet.
• The PC with Laser Marker NAVI smart installed
• PLC or PC for control: Externally controls the laser marker using the communication commands.
• Specified external devices: Interfaces the specified external device (image reading equipment) with the laser marker
and controls their operations.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• If you want to perform Ethernet communication for the above multiple purposes, use an expansion hub.
3. RS-232C port: RS-232C
The port to connect the following external devices for the communication control of the laser marker using RS-232C.
• PLC or PC for control: Externally controls the laser marker using the communication commands.
• Code reader compatible with the RS-232C communication: Modifies the data to mark by the laser marker according
to the code details read by the code reader.
4. Signal connector: SIGNAL
This is the terminal for communicating between head and controller. Connect the attached signal cable.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• For the connecting details, refer to “2-6-1 Connection of head and controller” (P.59).
5. Mini DIN connector:MIDI
Not used in this product. Do not connect anything.
ME-LPRH-SM-3