Panasonic LP-M Series, Руководство по обслуживанию

Страница: 73 / 174

73
3-2-1 DIP switch setting
Set the operational options for the external control with the DIP switch equipped on the controller rear side.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• The initial setting of all DIP switches is OFF.
• Turn OFF the power at DIP switch setting.
• For the details on DIP switch, refer to “2-2-3 DIP switch” (P.46).
1.
Turn OFF the power of laser marker.
2.
Remove the DIP switch cover on the rear of the controller.
ON
OFF
Rear of controller
DIP switch
3.
With DIP switch No. 2, select the control method, I/O or command
for some specific operations.
DIP switch No. 2 Control method for specific operations
ON Control by serial communication commands for the
following operations
• Laser pumping (LSR)
• Shutter control (SHT)
• Guide laser (GID)
• Laser check radiation (SPT)
• Laser power measurement (PWM)
• Test marking (TST)
OFF (initial setting) Control by I/O for the following operations
• Laser pumping
• Shutter control
• Guide laser
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• “Laser check radiation”, “Laser power measurement” and “Test marking” cannot be controlled by I/O. They can be
controlled only by using serial communication in the remote mode.
ME-LPM-SSM-10