Panasonic LP-M Series, Руководство по обслуживанию

Страница: 40 / 174

40
2-2 Name of Each Part
2-2-1 Head
3
4 7
8
6
9
1
2
5
1. Signal connector: SIGNAL
This is the terminal for communicating between head and controller.
Connect the attached signal cable.
2. Power connector: POWER
This is the connector for supplying the power to the head.
Connect the attached unit power cable.
3. Laser radiation indicator
This indicator indicates the laser radiation state. Refer to “Safety functions on laser marker” (P.21).
4. Laser pointer emission port
The emission port of the red laser pointer radiated when using the dual pointer function. For details, refer to “2-3-6
Lasing position check” (P.56).
To use the dual pointer function, do not seal the laser pointer emission port at the installation.
5. Frame ground terminal: F.G.
This is the terminal for ground. Be sure to connect it to earth permanently.
6. Fiber cable
This is the cable for transmitting the laser. This cable cannot be detached from the device.
7. Laser emission port
The emission port of the marking laser and the guide laser.
ME-LPM-SSM-10