Panasonic LP-400 Series, Руководство по внешнему управлению

Страница: 94 / 180

94
⿎ Bar code marking data (ASCII code specified) : BCS
Sets character string to be encoded as a bar code or 2D code by ASCII code. For alphanumeric and symbols only.
• Setting / Readout data of marking character string
STX BCS
Sub
command
[Bar code No.] [Line No.]
[Bar code data]
Max. 33-byte
(Check sum) Delimiter
Sub command is “S” at the time of setting and “A” for response data at the time of readout.
• Readout request of bar code setting (one-byte character)
STX BCS R
[Bar code No.] [Line No.]
Max. 3-byte
(Check sum) Delimiter
Name
Data length
[byte]
Description Remarks
Bar code No. 1 “0”–“7”
Line No. 1 or 2
1D code: “1”–“2”
2D code: “1”–“9”
2D part of Composite code: “01”–“09”
Specifies the line for data setting.
Bar code data Max. 30
ASCII code characters within the range
from 20(HEX) to 7E(HEX).
(Functional characters should not be
included.)
FNC1 can be entered at 1D(HEX).
Specifies the character setting in the
specified line.
Specify the data length with 0 byte in
order to delete the character string.
Reference
• When setting bar code marking data in multiple lines, data in each line are jointed in the order of line numbers and they
are coded as the data in one line. (No line break is inserted for each line.)
• When setting bar code marking data in multiple lines, the total input data should be 255 characters or less.
• If readout data includes function characters (such as “%SFT:0”), the setting character (“%SFT:0”) is read out, but
characters to be actually marked are not.
• If readout data includes characters that cannot be expressed in ASCII code such as Katakana and Kanji (Shift-JIS Code
Specified), only these 2-byte characters are read out in shift-JIS code. In this case, the maximum readout data will be
33-byte or more.
• Use the BBS command or BRS command when bar code data includes a control code.
• In the case that “GS1 Data Matrix” is selected as bar code type in bar code condition setting, the separator of variable
length AI data is inputted at GS (1D(HEX)) in this command. The separator can be coded as “FNC1” or “GS”. Set
beforehand either “GS” or “FNC1” as the separator in Environment 3 on the environment setting screen.
• For CODE128 (GS1-128), GS1 DataBar Expanded, and 2D side of composite codes, the separator of variable length AI
data “FNC1” can be input by using 1D(HEX).
ME-LP400V-EX-6