Panasonic LP-400 Series, Руководство по внешнему управлению

Страница: 37 / 180

37
Terminal
No.
Name/Description
20
21
22 SELECT 0
SELECT 1
SELECT 2
With SELECT 0 to SELECT 2, the setting target of D0 to D15 are specified as shown in the table below.
While maintaining the input status of SELECT 0 to SELECT 2 and D0 to D15, turn on SET IN.
Number input target SELECT 0 SELECT 1 SELECT 2
File No. OFF OFF OFF
Count-up value correction OFF ON OFF
Count-down value correction ON ON OFF
Counter No. to reset OFF OFF ON
Data number for Rank/External offset ON OFF OFF
* The select input (SELECT 0 to SELECT 2) is not necessary to be switched to ON when specifying the
file number.
23 TIME HOLD: Time hold input
Performs marking of date and lot, reflecting the time when the input TIME HOLD (No. 23) is turned ON.
While this input is turned on, the laser marker retains the time and date of the internal clock at the point
when the input was turned ON, and the functional characters such as current date, expiry date, and lot are
marked with this time.
If the input TIME HOLD (No. 23) is turned ON when powering on the laser marker, it retains the system
startup time.
24 to 29 RESERVE: System reservation
Do not connect externally.
*1 : Signals of No. 1 and No. 37 are different depending on the controller type of NPN or PNP.
• NPN models: LP-4xx(T)U / LP-4xx(T)U-A / LP-4xxS9(T)U / LP-4xxS9(T)U-A / LP-VxxU / LP-VxxU-A / LP-W series
• PNP models (with “-C” in the end of the model name): LP-4xx(T)U-C / LP-4xxS9(T)U-C / LP-VxxU-C
ME-LP400V-EX-6