Panasonic LP-400 Series, Руководство по внешнему управлению

Страница: 138 / 180

138
• Response to readout designation of power check result
STX PWR A
[Current power] [Power after correction]
[Power correction ratio] [Correction date]
[Total laser radiation time]
32-byte
(Check
sum)
Delimiter
Name
Data
length
[byte]
Content Remarks
Current power 3 “000”–“xxx”
Indicates the current power ratio [%] in comparison with
the default laser power.
Power after
correction
3 “000”–“xxx”
• The value obtained by multiplying the current power
by the power correction ratio is indicated.
It may differ from the calculated value depending on
the correction ratio.
• When the power correction has not been performed,
this value is “000”.
Power
correction ratio
5 “050.0”–“200.0” [%]
When the power correction has not been performed,
this value is “000”.
Correction
date
14
For 15:00:00 on April 1, 2012
“20120401150000” When the power correction has not been performed,
this value is “00000000000000”.
Total laser
radiation time
9 “0000000.0”–“1000000.0” [h]
Reference
• Power correction refers to the function to correct not the max. laser power [W] value but the laser power setting value.
Power correction does not change the actual max. output power relative to initial power.
⿎
Error code : ECR
Reads out the error code of alarm or warning when an error has occurred.
• Readout request of error code
STX ECR R (Check sum) Delimiter
• Response to error code readout
STX ECR A
[Error code] [Error type]
5-byte
(Check
sum)
Delimiter
Name
Data length
[byte]
Content Remarks
Error code 4
“0000” : No error
“E001”–“E999” : Error codes
Error type 1
“0” : No error
“1” : Alarm (due to system abnormality)
“2” : Alarm (due to control or settings)
“3” : Warning
Reference
• Refer to “Error Indication” (P.151) for details on error codes.
ME-LP400V-EX-6