Panasonic LP-400 Series, Руководство по внешнему управлению

Страница: 132 / 180

132
⿎ Marking quality adjustment : WTC
Sets laser start point, end point, edge and curve adjustments, etc.
• Setting / Readout data of marking quality adjustment
STX WTC
Sub
command
[Adjustment of starting point] [Adjustment of ending point]
[Edge adjustment] [Curve adjustment] [Waiting time]
[Pre-scan time] [Jump adjustment] [Point radiation ON]
[Point radiation OFF]
Max. 33-byte
(Check
sum)
Delimiter
Sub command is “S” at the time of setting and “A” for response data at the time of readout.
• Readout request of marking quality adjustment
STX WTC R (Check sum) Delimiter
Name Data length [byte] Description Remarks
Adjustment of
starting point
4 “-100”–“+100” The timing of starting laser is adjusted.
Adjustment of
ending point
4 “-100”–“+100” The timing of stopping laser is adjusted.
Edge adjustment 3 “000”–“100” The wait at edge is adjusted.
Curve adjustment 3 “000”–“100” The wait at curved line is adjusted.
Waiting time 3 “000”–“100” The waiting time is adjusted.
Pre-scan time 5 “00.00”–“10.00” [ms] The pre-scan time is adjusted.
Jump adjustment (3) “000”–“100”
The correction value of galvano jump is
adjusted. (omissible)
Point radiation ON (4) “0.00”–“9.99” [ms]
The timing of the point radiation ON is
adjusted. (omissible *)
Point radiation
OFF
(4) “0.00”–“9.99” [ms]
The timing of the point radiation OFF is
adjusted. (omissible *)
* Only one of [Point Radiation ON] and [Point Radiation OFF] cannot be omitted. (Response is not omitted.)
When setting arbitrary point radiation ON/OFF adjustment, jump adjustment is not omissible.
ME-LP400V-EX-6