Panasonic LP-400 Series, Руководство по внешнему управлению

Страница: 109 / 180

109
⿎ 2D code pattern : BRP
Sets 2D code module marking pattern.
• Setting / Readout data of 2D code pattern
STX BRP
Sub
command
[Bar code No.] [Pattern type] [Character code]
[Laser power correction] [Scan speed correction]
[Laser pulse cycle correction]
15-byte (LP-V series), 12-byte (LP-400/LP-W series)
(Check
sum)
Delimiter
Sub command is “S” at the time of setting and “A” for response data at the time of readout.
• Readout request of 2D code pattern
STX BRP R
[Bar code No.] [Pattern type]
2-byte
(Check sum) Delimiter
Name
Data
length
[byte]
Description Remarks
Bar code No. 1 “0”–“7”
Pattern type 1
• QR code:
“0”: Margin
“1”: Dark Module
“2”: Light Module
“3”: Alignment
“4”: Finder
• Data Matrix code:
“0”: Quiet Zone:
“1”: Mark Module
“2”: Space Module
Character code 4
“0000”, “2230”–“2239” or
“8121”–“8152”
Specifies the character code to be used
as a pattern in JIS code. Set “0000” to
no marking pattern. However, when the
alignment finder pattern of the QR code is
set to “0000”, marking is performed using
the dark/light module.
Laser power correction 3 “000”–“200” [%]
• The correction ratio is calculated using
the value set at the laser setting as
100%.
• With LP-400/LP-W series, nothing
should be input in Laser Pulse Cycle
Correction.
Scan speed correction 3 “005”–“500” [%]
(Laser pulse cycle
correction)
(Only for LP-V series)
(3) “050”–“200” [%]
ME-LP400V-EX-6