Panasonic Live Production Suite Series, Руководство по эксплуатации

Страница: 108 / 176

– 108 –
Chapter 6 Input/Output Signal Settings — Setting input signals
Setting input signals
The rear of the Gateway Unit is equipped with SDI connectors for input and output.
f
Each Gateway Unit can accept input 12G SDI signals from 10 systems.
f
To configure the input signal settings, select the <IN OUT> button on the top menu
→
[SDI IN 1] to [SDI IN 20].
f
The frame synchronizer setting and freeze setting can be set for all the terminals on each of the input boards.
Setting the frame synchronizer
The frame synchronizer can be set enabled/disabled for each input.
1
Select the <IN OUT> button
→
[SDI IN 1] to [SDI IN 20]
→
[Frame Buffer] tab.
2
Select an item in [FS] in the [SDI IN 1] to [SDI IN 20] columns.
[On] Enables the frame synchronizer function.
[Off] Disables the frame synchronizer function.
f
When the output signal phase is set to [0H], [FS] cannot be set to [Off].
For details, refer to “Setting the output phase”.
@ @ NOTE
t
Line synchronizer function is active while the frame synchronizer function is set to [Off].
t
The line synchronizer function automatically adjusts the input video signal phase to the horizontal sync signal phase.
For details, refer to “Setting the output phase”.
Freezing input signals
The input signals can be frozen and used. While signals are frozen, the tally signals of the corresponding input will not be output. When the system
format is progressive, the menu is not displayed and settings are not possible.
Setting the freeze mode
1
Select the <IN OUT> button → [SDI IN 1] to [SDI IN 20] → [Frame Buffer] tab.
2
Select an item in [Freeze] in the [SDI IN 1] to [SDI IN 20] columns.
f
An item can also be selected while an image is frozen.
[ON] Freezes the images frame by frame.
[OFF] There is no freezing.
Setting the source name
The source names displayed on the Control Panel and the MultiView display can be set from the <NAME> button on the top menu → [SDI IN]/[IP IN]/
[INTERNAL]/[ME]/[DSK]/[AUX]/[MV] → [Panel Name]/[MV Name] tab.
For details, refer to “Setting the source name”.
Displaying video input signal information
Displaying the SDI input signal information
Display the information concerning the SDI input signal images.
f
The information cannot be changed.
1
Select the <IN OUT> button
→
[SDI IN 1] to [SDI IN 20]
→
[Status] tab.
2
Check the [SDI IN 1] to [SDI IN 20] columns.
[Format]
Displays the input format.
When there is no input signal, [No signal] is displayed.
For formats that are not supported, [Undefined] is displayed. If horizontal pixels are the same, false detection may occur.