EN-
50
EN-
51
English
2. Embed the appliance in the countertop cutout
while keeping it is as level as possible.
■
Do not drop the appliance on the countertop.
■
Press down on top of the appliance to make
sure that it rests on the countertop.
■
Make sure that the spaces between the
countertop and the under surface of the
appliance are even in the front, rear, left and
right.
1. Fasten the clamps to the appliance.
(2 places at
rear)
■
Place the appliance on the packaging upper
fi ller when fi tting clamps to prevent damage to
the countertop.
■
Match the clamp grips with the holes on the
sides of the appliance, then slide the clamp
from the right to the left to fasten them to the
appliance.
3. Connect the power cord.
■
See page 49.
Installing the Appliance
WARNING
Do not disassemble the top plate. Connected wire may become loose
and cause a malfunction.
CAUTION
If the cabinet does not have an opening in the front, the wiring needs
to be connected before the appliance is embedded into the countertop.
Correct
Incorrect
Upper fi ller
Installing the appliance as fl ush-fi tting
This appliance can be fi tted fl ush when installing.
Flush-fi tting
■
Only suitable for installation on heat and water resistant worktops such as
marble, natural stone, solid wood (if cut out edges are sealed).
■
Mount onto other types of worktops only with the recommendation of the worktop
manufacturer.
■
Remove the cushion from the underside of the appliance before fl ush fi tting.
■
The internal width of the base unit must be at least as wide as the internal
cut-out width for the hob. This is to ensure that the casing can be easily removed
for maintenance.
■
Before sealing in, test that the appliance works. Grout the perimeter using a heat
resistant silicone. Smooth the seal with a suitable fi nishing product.
Follow the silicone instructions and do not turn on the appliance until the silicone
is completely dry.
CAUTION
■
Please observe the diagrams for the cut-out dimensions in granite
and marble worktops.
■
Using unsuitable silicone may cause permanent colour changes to
marble worktops.
Uninstalling the appliance as fl ush-fi tting
■
Disconnect the appliance from the mains.
■
Remove the silicone seal from the perimeter with a suitable tool.
■
Push the appliance upwards from below to remove it.
CAUTION
Do not try to remove the appliance by prying it out from above.
490
870
904
17
5.5
R3
R3
29
524
(measurement: mm)
