Panasonic KX-VC300CN, Руководство по установке

Страница: 42 / 64

•
You cannot use a contact list whose version
is older than 1.03 (not including 1.03). The
version of the contact list is displayed in the
<AddressVersion> field of the downloaded
contact list data. If the version of the contact
list is older than 1.03, update the software
of the unit to update the version of the
contact list to 1.03, and then download the
contact list.
9.
Click [Browse…] for [Select a file to upload:] under
[Data Upload To Main Unit]
®
[Upload contact
list] on the System Operation screen, then navigate
to the edited data.
10.
Click [upload] under [Data Upload To Main Unit]
®
[Upload contact list] on the System Operation
screen.
•
The data is uploaded to the unit and [file upload
success] is displayed on the Web browser.
•
If [upload file commit error] is displayed on the
Web browser, the uploaded data may contain
an error. Refer to the error message and correct
the error.
Or, you may be trying to upload a contact list
whose version is older than 1.03. Check the
<AddressVersion> field in the contact list data
that you are trying to upload. If the version of the
software is not 1.03, contact your dealer.
11.
Turn the power off and back on to restart the unit.
Note
•
Make sure you do not access any Web sites
while performing settings on the System
Operation screen.
•
Make sure to close the browser after finishing
performing settings.
6.5.4 Entering the Device Name
When entering data apart from that which can be
entered using the remote control, follow the procedure
below.
1.
Perform steps 1–7 in "Starting and Operating a
Terminal Emulator" (Page 37).
2.
Enter "devinfo set name XXXX", then press [Enter].
•
For XXXX, enter a device name.
•
The following number of characters can be
displayed on the screen:
–
When using Alphabet: Up to 24 characters
–
When using Kanji (Chinese characters): Up
to 18 characters
•
Make sure to set the terminal emulator to use
UTF-8 encoding. If UTF-8 is not set, the entered
information may not be recognised and the
initial screen will be displayed after restart.
•
If undisplayable characters are set, they will not
be displayed on the screen.
3.
Enter "syssave", then press [Enter].
•
The value is saved as configuration data.
4.
Turn the power off and back on to restart the unit.
42 Installation Manual
6 Settings and Confirmation