Answering a Video Conference Call
Depending on your setting, you can either respond to a request to participate in a video conference call
manually (manual answer) or automatically (automatic answer) (Page 90).
Note
•
Make sure that peripheral devices (e.g., display, main video camera) are turned on.
When Manual Answer is Set
When a video conference call is incoming there will be an incoming call ring, and a dialog box is displayed.
When the caller is registered in the contact list, the caller’s
group/site is displayed.
When the caller is not registered, the caller’s IP address (or
host name)/SIP-URI is displayed.
Note
•
If the other party uses the same SIP domain name as you, only the SIP user name, and not the SIP
URI (SIP user name@SIP domain name) is displayed.
•
If the caller’s group/site name, or SIP URI (or SIP user name) is too long to display, it will be shortened
and ended with "..." .
Operation
1
Press
[Start]
.
•
The video conference begins.
•
You can also answer the video
conference call by pressing
[Enter]
.
1
Note
•
If you do not answer a video conference call within approximately 60 seconds, the call will be terminated
automatically.
When Automatic Answer is Set
When a video conference call is incoming the call will be automatically answered after one ring, and
transmission then begins.
Document Version 2012-03
Operating Manual
47
Starting a Video Conference
