Panasonic KX-VC1300, Руководство пользователя, Страница: 119 / 200

Performing a Network Test
You can confirm whether a network connection can be
established with a particular IP address.
Note
•
You cannot perform a network test from the
contact list screen or the call history screen.
1.
Select "Network Test" and press [ENTER] .
•
The network test screen is displayed.
2.
Enter an IP address.
Note
•
If an IPv4 address contains 1 or 2 digit
numbers, enter these numbers as they are.
Do not enter like [.001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
•
For the input format when an IPv6 address
is used, refer to Page 43.
3.
Press [R] .
•
The network test starts. After the network test is
finished, if the network test was successful or
timed out, the details of the results are
displayed. If the network test failed, a message
indicating the failure is displayed.
4.
Press [BACK] .
•
The system setting screen is displayed.
Performing Self Diagnosis
You can check how your image will be displayed and
how your voice will be heard to the other party before
starting a video conference call, using your own display
and speakers.
Note
•
Self diagnosis can be performed even when a
headset is connected.
1.
Select "Self Diag." and press [ENTER] .
•
The self diagnosis screen is displayed with the
dialogue box.
Note
•
You can hide or display the dialogue box by
pressing
[B] .
•
Set the microphone at least 1 m (3.3 ft)
away from the speakers.
2.
Press [R] .
•
The self diagnosis starts.
Note
•
Check the image that is displayed from the
main video camera.
•
To avoid feedback, slowly raise the volume
using the remote control’s
[+] button.
•
When someone speaks into the
microphone, confirm whether the sound
plays back through the speakers.
•
During self diagnosis, all Boundary
Microphones will be set to
"Center
stereo" .
•
During self diagnosis, the tone will be set to
"Standard" .
3.
Press [R] .
•
The self diagnosis ends.
Note
•
If you do not press [R] , the self diagnosis
will automatically end after about
10 minutes.
4.
Press [BACK] .
•
The system setting screen is displayed.
Displaying the Licence
Information
You can display information about the licence and Open
Source Software.
1.
Select "License Info." and press [ENTER] .
•
The licence information display screen is
displayed.
•
Press [R] to move to the next page, and press
[B] to move to the previous page.
2.
Press [BACK] .
•
The system setting screen is displayed.
Displaying the End-User
Licence Agreement
You can display information about the End-User
Licence Agreement.
Document Version 2015-12 User Manual 119
Contacts and Settings