Panasonic KX-UTG200, Руководство по установке, Страница: 29 / 412

Configuring the Network Settings of the Unit
The following procedures explain how to change the network settings via the unit.
For details about the individual network settings that can be configured via the unit, refer to the Operating
Instructions on the Panasonic Web site (
®
see Introduction ).
For details about configuring network settings via the Web user interface, see 4.3.1 Basic Network
Settings .
Settings for IPv4
To configure network settings automatically
1.
On the Home screen, select .
2.
Select "Network Settings", and then press [ENTER] .
3.
Select "Network", and then press [ENTER] .
4.
Select "IPv4", and then press [ENTER] .
5.
Select "DHCP", and then select
Yes
.
6.
Select "Auto DNS", and then select Yes .
•
Select No to enter the addresses for DNS1 (primary DNS server) and, if necessary, DNS2
(secondary DNS server) manually.
To configure network settings manually
1.
On the Home screen, select .
2.
Select "Network Settings", and then press [ENTER] .
3.
Select "Network", and then press [ENTER] .
4.
Select "IPv4", and then press [ENTER] .
5.
Select "DHCP", and then select
No
.
6.
Select "Auto DNS", and then select No .
7.
Enter the IP address, subnet mask, default gateway, DNS1 (primary DNS server), and, if necessary, DNS2
(secondary DNS server).
Settings for IPv6
To configure network settings automatically
1.
On the Home screen, select .
2.
Select "Network Settings", and then press [ENTER] .
3.
Select "Network", and then press [ENTER] .
4.
Select "IPv6", and then press [ENTER] .
5.
Select "Enable IPv6 DHCP", and then select
Yes
.
6.
Select "IPv6 Auto DNS", and then select
Yes
.
•
Select
No
to enter the addresses and other settings as necessary.
To configure network settings manually
1.
On the Home screen, select .
2.
Select "Network Settings", and then press [ENTER] .
3.
Select "Network", and then press [ENTER] .
4.
Select "IPv6", and then press [ENTER] .
5.
Select "Enable IPv6 DHCP", and then select
No
.
6.
Select "IPv6 Auto DNS", and then select
No
.
7.
Enter the IP addresses and other settings as necessary.
Document Version 2015-01 Administrator Guide 29
1.1.2 Basic Network Setup