Panasonic KX-TVM50, Руководство по программированию

Страница: 42 / 200

2.1 Mailbox Settings
42 Programming Guide
Feature Guide References
2.4.9 Calling a Beeper (Pager)
Device Notification for Unreceived Message
If set to "Yes", the VPS calls the appropriate device in numerical order until unplayed messages are
received.
Value Range
No, Yes
Feature Guide References
2.3.29 Message Waiting Notification—Device
Notification Schedule
Specifies the Message Waiting Notification schedule for each device. The following parameters can
be specified per device.
Follow the steps below to edit Notification Schedule:
1.
Click Click to edit….
2.
Select a device (Device No. 1, Device No. 2, Device No. 3) tab.
3.
Edit parameters.
4.
Click OK.
Notification Type
Specifies the type of message for which notification is sent. Notification can be sent for all messages,
or urgent messages only.
Value Range
All Messages, Only Urgent Messages
Feature Guide References
2.3.29 Message Waiting Notification—Device
Dial Number
Assigns a telephone or beeper (pager) number to Device 1, 2, or 3. The subscriber can also specify
the number to be dialled by entering it from his or her telephone, allowing the subscriber to set this
feature on a case by case basis.
Note
• The callback number entry code "X" must be included in the number to be called if the
Beeper Callback No. Entry Mode is enabled through COS and "Type of Device" is set to
"Beeper". The proper "Dial Pauses" must be inserted before the callback entry code.
• When the VPS calls a Trunk via a PRI (ISDN Primary Rate Access Interface) card of a
Panasonic PBX, please be sure to add "#" after the telephone number (1112223333 in the