alkaline batteries, insert the Ni-MH batteries
into the base unit again after the power is
restored so that they will be recharged.
Battery saving mode setting
This feature allows the base unit to reduce its
power consumption by limiting the available
functions and therefore extend battery life during a
power failure.
The following settings are available:
–
“
On
”
: The unit will work as a standard
telephone. Only the corded handset can be
used to make and receive calls. (You cannot
use the base unit display, phonebook,
one-touch dial, answering system,
speakerphone, etc.)
The base unit display is blank.
–
“
Off
”
(default): You can use the full functions
of the base unit, but battery life is not extended.
The brightness level for the base unit display is
lowered.
Base unit
1
M
N#150
2
MbN
: Select the desired setting.
3
M
OK
N
a
M
N
Note:
R
Once the battery saving mode is set to
“
On
”
,
the unit rings with the volume level 1 even if the
ringer volume for the base unit is set to
“
Off
”
to
let you know an incoming call is being received.
Panasonic Ni-MH battery performance
(optional batteries) when operating on backup
battery power
Operation
Saving mode
Off
On
In continuous use
3 hours
max.
10 hours
max.
Not in use (standby)
4 hours
max.
12 hours
max.
Note:
R
Battery performance depends on the type of
batteries.
R
Actual battery performance depends on usage
and ambient environment.
Note when setting up
Note for connections
R
The AC adaptor must remain connected at all
times. (It is normal for the adaptor to feel warm
during use.)
R
The AC adaptor should be connected to a
vertically oriented or floor-mounted AC outlet.
Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight of the
adaptor may cause it to become disconnected.
Note for Ni-MH battery installation
R
Handset:
Use the supplied rechargeable
batteries.
R
Handset/Base unit:
For replacement, we
recommend using the Panasonic rechargeable
batteries noted on page 4, 6.
Note for battery charging
R
It is normal for the handset to feel warm during
charging.
R
Clean the charge contacts of the handset and
charger with a soft and dry cloth once a month.
Before cleaning the unit, disconnect from power
outlets and any telephone line cords. Clean
more often if the unit is exposed to grease, dust,
or high humidity.
10
Getting Started
KX-TGF310_320CX(en)_0429_OI.pdf 10
4/29/2015 4:08:39 PM