Error messages
Display message
Cause/solution
Ask phone
company for
VM access #
R
You have not stored the voice mail access number. Store the
number (page 46).
Base no power
or
No link. Re-
connect base
AC adaptor.
or
No link.
R
The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R
Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R
The handset’s registration may have been canceled.
Re-register the handset (page 35).
R
When
“
No link.
”
is displayed during a power failure, place
a handset on the base unit to supply power to the base unit.
Busy
R
The called unit is in use.
R
Other units are in use and the system is busy. Try again later.
R
The handset you are using is too far from the base unit. Move
closer and try again.
Check tel line
R
The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 10).
Error!!
R
Recording was too short. Try again.
Invalid
R
There is no handset registered to the base unit matching the
handset number you entered.
R
The handset is not registered to the base unit. Register the
handset (page 35).
Requires
subscription
to Caller ID.
R
You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
Use
rechargeable
battery.
R
A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 5, 7.
50
For assistance, please visit http://www.panasonic.com/help
Useful Information
TGE21x23x24x(en)_1122_ver031.pdf50 50
2013/11/22 14:22:30