Baby monitor
This feature allows you to listen in on a room
where another handset is located, allowing
you to easily monitor from different areas of
the house or even while away from home. The
monitored handset (placed in a baby’s room,
for example) will automatically call the
monitoring handset, or the phone number
stored when it detects sound.
Important:
R
Before using this feature, we recommend
that you test it and adjust the baby monitor
sensitivity as needed, especially if you plan
to monitor from outside.
R
This feature should not be used as a
substitute for a medical or caregiver’s
supervision. It is the caregiver’s
responsibility to stay close enough to
handle any eventuality.
Note:
R
During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset
on charger.
R
The monitored handset never rings while it
is being monitored. If the base unit is
placed near the monitored handset, we
recommend turning off the base unit ringer
volume (page 20).
Setting the baby monitor
Perform the setting operation with the handset
to be monitored (for example, the handset
placed in a baby’s room).
To monitor with a handset
The internal baby monitor feature is only
available between handsets.
1
M
MENU
N#268
2
MbN
:
“
On
”
a
M
SELECT
N
3
MbN
: Select the desired handset’s number
to monitor with.
a
M
SAVE
N
R
“
Baby monitor
”
will be displayed.
R
The registered handset’s name/
number is displayed.
Note:
R
When this feature is on, another handset
can hear the monitored handset by making
an intercom call.
To monitor from outside
If you enable this feature, the unit will call a
pre-programmed phone number when the
handset detects sound. After you answer the
call, you can listen in on the room where the
handset is located.
n
From the phonebook:
1
M
MENU
N#268
2
MbN
:
“
On
”
a
M
SELECT
N
3
MbN
: Select
“
Outgoing call
”
to
monitor from outside.
a
M
ADD
N
4
MbN
:
“
Phonebook
”
a
M
SELECT
N
5
MbN
: Select the phonebook entry.
a
M
SAVE
N
R
“
Baby monitor
”
will be displayed.
Note:
R
If you edit a phonebook entry which is
assigned for monitoring, the edited entry
does not transfer to the monitor.
n
By entering phone numbers:
1
M
MENU
N#268
2
MbN
:
“
On
”
a
M
SELECT
N
3
MbN
: Select
“
Outgoing call
”
to
monitor from outside.
a
M
ADD
N
4
MbN
:
“
Manual
”
a
M
SELECT
N
5
Enter the desired name.
a
M
OK
N
6
Enter the desired number.
a
M
OK
N
a
M
SELECT
N
R
“
Baby monitor
”
will be displayed.
Note:
R
The registered name/number is displayed.
Turning off the baby monitor
The monitored handset cannot be used while
baby monitor is set to
“
On
”
.
1
Press
M
MENU
N
on the handset being
monitored.
2
MbN
:
“
On/Off
”
a
M
SELECT
N
42
For assistance, visit www.panasonic.ca/english/support
Programming
TGD890C(en)_0627_ver008.pdf 42
2023/06/27 12:17:25