Panasonic KX-TG8107UA, Руководство по обслуживанию

Страница: 58 / 91

58
KX-TG8107UA/KX-TG8108UA/KX-TGA810UA
11.4. The Setting Method of JIG (Handset)
11.4.1. Preparation
11.4.1.1. Equipment Required
• DECT tester: Rohde & Schwarz, CMD 60 is recommended.
• Frequency counter: It must be precise enough to measure intervals of 1Hz (precision; ±4ppm).
Hewlett Packard, 53131A is recommended.
• DC power: It must be able to output at least 1A current under 2.4V for Handset.
• Digital multi-meter (DMM): It must be able to measure voltage and current.
• Oscilloscope
11.4.1.2. JIG and PC
• Serial JIG
JIG Cable: PQZZ1CD300E*
• PC which runs in DOS mode.
•
Batch file CD-ROM for setting: PQZZTG8107UA
Note:
*: If you have the JIG Cable for TCD500 series
(PQZZ1CD505E), change the following values of resis-
tance. Then you can use it as a JIG Cable for both TCD300
and TCD500 series. (It is an upper compatible JIG Cable.)
11.4.2. PC Setting
11.4.2.1. Connections
Connect the DC Power or Battery to BATT+ and BATT- (Handset).
Connect the JIG Cable GND (black).
Connect the JIG Cable UTX (yellow) and URX (red).
Note:
*: COM port names may vary depending on what your PC calls it.
Resistor Old value (k
Ω
) New value (k
Ω
)
R2 22 3.3
R3 22 3.3
R4 22 4.7
R7 4.7 10