indicator
Status
Meaning
Green
(On)
Signal strength of the
base unit is strong.
Amber
(On)
Signal strength of the
base unit is weak.
Red
(On)
Out of base unit range.
Off
R
The unit is not being
used.
R
The power is off.
Installation
1
Connect the unit.
R
Use only the supplied Panasonic
AC adaptor PQLV219AL.
Press plug firmly.
Hook
(220-240 V AC, 50/60 Hz)
R
When the unit is turned on, the
indicator and indicator light
amber for about 2 seconds.
2
Confirm that the indicator and
indicator light green. (The unit
is ready for use.)
R
If the indicators do not light green,
re-position the unit in a place
where the indicators light green.
Note:
R
The AC adaptor must remain
connected at all times. (It is normal for
the adaptor to feel warm during use.)
R
The AC adaptor should be connected
to a vertically oriented or
floor-mounted AC outlet. Do not
connect the AC adaptor to a
ceiling-mounted AC outlet, as the
weight of the adaptor may cause it to
become disconnected.
R
The unit can support a maximum of 3
handsets at a time.
Setting the repeater mode
This repeater is pre-registered to the
base unit and the default setting of
repeater mode is
“
On
”
. You do not need
to change this setting for initial use.
1
M
MENU
N
#138
2
MbN
: Select the desired setting.
a
M
SAVE
N
a
M
OFF
N
Note:
R
After turning the repeater mode on or
off, is displayed on the handset
momentarily. This is normal and the
handset can be used once is
displayed.
Wall mounting
Note:
R
Make sure that the wall and the fixing
method are strong enough to support
the weight of the unit.
R
Drive the screws (not supplied) into
the wall.
37 mm
Screws
Wall mounting template
37 mm
57
DECT repeater
TG76xxAZ(en)_0207_ver012.pdf 57
2012/02/07 15:34:48
