Programming
23
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
busy tone to the caller, and then
disconnects the call.
Important:
L
When the unit receives a call from a
number that is stored in the call barred
list, the call is logged in the caller list
(page 26) with
7
after the call is
disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in
the call barred list by using the caller list
or by entering the numbers directly.
Important:
L
You must store the phone number
with an area code in the call barred
list.
■
From the caller list:
1
8
(middle soft key)
2
{V}
/
{^}
:
“
Caller List
”
i
M
3
{V}
/
{^}
: Select the entry to be
barred.
i
8
4
{V}
/
{^}
:
“
Add Bar List
”
i
M
5
{ih}
■
By entering phone numbers:
1
8
(middle soft key)
2
{V}
/
{^}
:
“
Caller Barred
”
i
M
i
~
3
Enter the phone number (24
digits max.).
i
M
L
To erase a digit, press
^
.
4
{ih}
Viewing/editing/erasing bar call
numbers
1
8
(middle soft key)
2
{V}
/
{^}
:
“
Caller Barred
”
i
M
3
{V}
/
{^}
: Select the desired entry.
L
To exit, press
{ih}
.
4
Proceed with the desired operation.
■
Editing a number:
8
i
{V}
/
{^}
:
“
Edit
”
i
M
i
Press
{^}
or
{V}
to move
the cursor.
i
Edit the number.
i
M
i
{ih}
■
Erasing a number:
8
i
{V}
/
{^}
:
“
Erase
”
i
M
i
{V}
/
{^}
:
“
Yes
”
i
M
i
{ih}
Note:
L
When editing, press the desired dial
key to add,
^
to erase.
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to
the base unit.
Important:
L
The additional handset model
recommended for use with this unit is
noted on page 4. If another handset
model is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example,
w
flashes even when the
handset is near the base unit), re-
register the handset.
1
Handset:
8
(middle soft key)
2
{V}
/
{^}
:
“
Handset Setup
”
i
M
TG6411-6421E(e).book Page 23 Tuesday, December 16, 2008 7:54 AM
