Useful Information
49
Error messages
*1 KX-TG3721/KX-TG3821 series: page 3, 4
*2 KX-TG3712/KX-TG3722/KX-TG3822
Display message
Cause/solution
Base no power
or
No link. Reconnect
AC adaptor.
or
No link.
L
The handset has lost communication with the base unit. Move
closer to the base unit and try again.
L
Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L
The handset’s registration may have been canceled. Re-
register the handset (page 54).
L
When
“
No link.
”
is displayed during a power failure, place
a handset on the base unit to supply power to the base unit.
Check Phone Line
L
The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 9).
Dial Locked
L
Dial lock is turned on. To turn it off, see page 21.
Error
L
Recording was too short. Try again.
L
The entered password was wrong in programming dial lock.
Enter the correct password.
Failed
L
Phonebook copy failed (page 26). Confirm the other handset
(the receiver) is in standby mode and try again.
L
The receiver’s phonebook memory is full. Erase the
unwanted phonebook entries from the other handset (the
receiver) and try again.
Memory Full
L
The phonebook memory is full. Erase unwanted entries (page
25).
L
Message memory is full. Erase unwanted messages (page
38, 39).
L
The call barred list memory is full. Erase unwanted entries
(page 33).
Use rechargeable
battery.
L
A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 5, 7.
You must first
subscribe to Caller
ID.
L
You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
TG37xx38xxBX(e).book Page 49 Wednesday, June 8, 2011 2:08 PM