38
Selecting the Stand-by Mode Display
Bell Selection
1
Press
then
.
2
Press
.
3
Enter the base unit password (p. 27).
•
The current setting is displayed.
1: All handsets
2: Specified handset(s)
3: First handset
1
I N T
PROG
4
Press
.
•
The current registered handset number(s)
is/are displayed.
5
Enter the handset number(s) you want to
ring.
•
The selected handset number(s) flash(es).
•
If you misdial, press the number(s) again.
6
Press
.
•
A confirmation tone sounds and the
display will return to the stand-by mode.
PROG
2
There are three choices for bell selection. When a call is being received:
— all handsets ring. “All handsets”
— the selected handset(s) ring(s). “Specified handset(s)”
— the selected handset rings first, then if it does not answer, all other handsets will ring. “First
handset”
The factory preset is “All handsets”. To change the bell selection, program as follows.
Selecting specified handset(s)
You can choose which handset(s) you want to ring.
You can choose whether to display the currently connected base unit number, handset number or no
display while in the stand-by mode. The factory preset is the base unit number.
1
Press
.
2
Press
G
or
F
until “
F3 i
” is displayed,
then press
.
•
The current setting is displayed.
1: Base unit number
2: Handset number 0: No display
OK
PROG
3
Press
G
or
F
to select the desired
setting.
•
You can press
,
or
to select
the setting.
4
Press
.
•
A confirmation tone sounds and the
display will return to the stand-by mode.
PROG
0
2
1
F3 i
0
i
i
u
i
Ex. All handsets is selected.
i
u
2- i23456
Ex. Handset number is selected.
Ex. Handset 1, 2, 3, 4, 5 and 6 are registered.
[ 2 ]
KX-TCD952EB(034~039) 00.3.30 1:39 PM Page 38
