1.1 Incoming Call Features
20
Feature Guide
•
If the intercept destination can, but does not, answer the call:
The call continues to ring at the intercept destination until answered.
•
Intercept Routing—Busy/DND on/off
Intercept Routing—Busy and Intercept Routing—DND can each be enabled or disabled for the entire
system, through system programming. If enabled, calls will be routed to the appropriate destination.
If disabled, the caller will hear a ringback tone. If busy, the extension will not ring. If in DND mode, the
extension will ring.
•
Idle Extension Hunting
If an extension is a member of an idle extension hunting group, calls to that extension will not be
redirected by Intercept Routing—Busy/DND. If the extension is busy or in DND mode, calls to that
extension will be redirected to the next extension in the idle extension hunting group.
Feature Guide References
1.3.1 Call Forwarding (FWD)/Do Not Disturb (DND)
1.1.1.5
Intercept Routing—No Destination
Description
Directs a CO line call to an operator when the call has no assigned destination.
Conditions
•
If an operator is not assigned:
The default intercept destination will be the extension connected to the lowest numbered port, on the
card installed in the lowest numbered slot.
•
Intercept Routing—No Destination also applies to calls from doorphones.
Feature Guide References
1.1.2
Internal Call Features
1.1.2.1
Internal Call Features—OVERVIEW
Description
There are two types of internal calls, described below.
Feature
Description
Details in
Intercom Call
A call from one extension to another.
Doorphone Call
A call made from a doorphone to its preprogrammed
destination, assigned to the doorphone's port, for the
current time mode. (
→
Содержание KX- TAW848
