Panasonic KX-T336, Справочное руководство системы

Страница: 1342 / 1605

12-C-15
4.00 Automatic Line Hunting
(Calling) Selection
This feature automatically connects a PITS
telephone to a pre-assigned line when an
extension user lifts the handset or press the SP-
PHONE to make calls.
There are two options by which an extension user
may select a desired line:
• Prime Line Preference-Calling (Default)
• Idle Line Preference-Calling
Result
Operation
Comment/Note
• This status is called “Initial
display for PITS-station
programming mode.”
• If the following message
appears on the display, the
programming data of your
PITS has already been
accessed by another
administration device:
Already Accessed
• From now on in any status,
pressing the END button
restores this status.
• If nothing is entered within one
minute after dialing “00,”
“Initial display for PITS-
station programming mode” is
shown again on the display.
• To change the assignment,
simply dial the appropriate
number again.
1. Set the MEMORY switch at
the rear of PITS to
“PROGRAM.”
2. Dial “00.”
3. To change the preset
feature, dial the appropriate
program number
corresponding to the desired
feature.
• To set “No Line Preference,”
dial “1.”
• The following message
appears on the display:
PITS-PGM No.?
• The MEMORY button indicator
lights in red.
• Preset data appears on the
display:
<Example>
If No Line Preference is
preset:
Pref. Out : No.
• The MEMORY button indicator
light goes out.
• The following message
appears on the display:
Pref. Out : No.
SET• • PROGRAM
MEMORY
Continued
If “No Line Preference-Calling” is selected, no line is
connected to a PITS telephone by lifting the handset
or pressing the SP-PHONE button.
For further information about this feature, refer to
Section 4-C-1.00 “Line Selection-Calling.”
The table shows the operation for each programming.
(The explanation of the message display applies only
to a PITS provided with the display.)