Panasonic KX-NS700, Руководство по установке

Страница: 151 / 308

2.
Turn on the power switch of the PBX. The STATUS indicator will flash green.
3.
While the STATUS indicator is flashing green, slide the System Mode Switch back to the "NORMAL"
position. Depending on the configuration, initialization takes about 2.5 minutes. If successfully executed,
the STATUS indicator will stop flashing and remain lit up.
Note
When a DSP card is installed and a DHCP server is not connected, installed DSP card cannot acquire
an IP address, and the STATUS indicator will turn red.
All data, except for system prompts and activation key files, will be erased. Data that is erased includes Unified
Messaging data, call logs, etc. The settings for the PBX as well as all optional service cards will be initialized
to their default values.
Note
•
After the PBX is initialized, you can restore system data to the PBX that has been backed up earlier.
For details about backing up and restoring system data, refer to "6.1 Tool—System Data Backup",
"7.2.2 Utility—File—File Transfer PBX to PC" and "7.2.1 Utility—File—File Transfer PC to PBX" in
the PC Programming Manual.
•
After the PBX is initialized, you must set up the mandatory settings required for the PBX with Easy
Setup Wizard. For details refer to "Connecting to Web Maintenance Console" and "5.4.1 Easy Setup
Wizard".
•
When a UPS is connected, make sure it is started as instructed in the documentation for the UPS.
Confirming the CO Line Connection
After the PBX starts up, program the PBX and connect CO lines to the PBX.
To confirm that the CO lines are successfully connected, dial [ ] [3] [7] + CO line number (3 digits) on an IP
telephone, or press the IP/DPT/APT telephone’s S-CO button. You will hear a dial tone if the CO line is available
and connected.
Document Version 2016-03 Installation Manual 151
4.13 Starting the PBX