Panasonic KX-NS300CN, Руководство по программированию ПК

Страница: 713 / 884

Telephone Device
Specifies the Message Waiting Notification schedule for each device. The following parameters can be
specified for devices 1, 2, and 3. Click
Edit for the extension to change, set Device Notification for
Unreceived Message to "Yes", and programme the settings, then click OK to finish.
Feature Guide References
3.2.1.30 Message Waiting Notification—Telephone Device
Telephone Device—Device No. 1, 2, 3—Only Urgent Messages
Specifies if notifications will be sent only for messages designated as urgent.
Value Range
Yes, No
Feature Guide References
3.2.1.30 Message Waiting Notification—Telephone Device
Telephone Device—Device No. 1, 2, 3—Dial Number [0-9 * # T X , ;]
Assigns a telephone number to Device 1, 2, or 3. The subscriber can also specify the number to be dialled by
entering it from his or her telephone, allowing the subscriber to set this feature on a case by case basis.
Note
When the Unified Messaging system calls a trunk via the PRI card, be sure to add "#" after the telephone
number (1112223333 in the example here): 9P1112223333#PP123PP456PPX# (P: Dial Pause)
Value Range
Max. 32 digits consisting of 0–9, , # and special codes:
, : Dial Pause (default 1 s)
; : Dial Pause (default 3 s)
T : Dial Tone Detection
X : Callback Number Entry Code
0–9, , # : Dial Code
Feature Guide References
3.2.1.30 Message Waiting Notification—Telephone Device
Telephone Device—Device No. 1, 2, 3—No. of Retries
Specifies the number of times the Unified Messaging system will try to send notification if the device is busy
or if there is no answer.
Value Range
0–9 times
Feature Guide References
3.2.1.30 Message Waiting Notification—Telephone Device
PC Programming Manual 713
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting