Panasonic KX-MB2085CXW, Руководство по обслуживанию

Страница: 85 / 276

85
KX-MB2085CXW/KX-MB2090CXW
12 Troubleshooting Guide
12.1. User Recoverable Errors
If the unit detects a problem, one or more of the following messages will appear on the display.
The explanations given in the [ ] are for servicemen only.
Display Cause & Solution
• Polygon motor error.
Refer to CALL SERVICE 1 (P.101).
• Laser beam error. Replace LSU unit.
Refer to CALL SERVICE 2 (P.102).
• Fuser unit cannot heat up. Replace fuser unit.
Refer to CALL SERVICE 3 (P.103).
• Fan motor error. Replace fan motor.
Refer to CALL SERVICE 4 (P.104).
• Print motor error. (only for DC motor)
Refer to CALL SERVICE 5 (P.105).
• Detection of charger error
Refer to CALL SERVICE 6 (P.106).
• There is something wrong with the drum cartridge. Replace the drum cartridge and the toner cartridge.
• The document was not fed into the unit properly. Remove the document, and then press [STOP] to clear
the message. Re-insert the document. If misfeeding occurs frequently, clean the document feeder rollers
and try again.
• The ADF top cover is not fully closed. Push firmly on the front and rear edges of the ADF top cover, and
then feed the document again.
• The drum cartridge is not inserted properly. Re-insert it correctly.
• Recording paper is not installed or the paper input tray has run out of paper. Install paper.
• Recording paper was not fed into the unit properly. Re-insert the recording paper.
• The paper input tray is not installed or is not inserted completely. Insert the paper input tray into the unit.
• The loaded recording paper is not the appropriate size. Load recording paper of the size that is shown on
the display.
• If this message is often displayed, also change the recording paper size setting.
• The recording paper size setting is set to “B5 (ISO)”, “B5(JIS)” or “16K”, so received faxes have been
stored into memory. Change the recording paper size setting and load the appropriate recording paper
Note:
• “#1”: Check the paper input tray. The displayed paper size depends on the recording paper size setting.
• “#2”: Check the manual input tray. The displayed paper size depends on the recording paper size setting.
• Recording paper was not fed into the unit properly. Load the paper again.
• The manual input tray (rear cover) is open. Close it.
• A recording paper jam occurred near the manual input tray (rear cover). Remove the jammed paper.
• The unit is cooling down the fuser unit. Wait for a while.
• The rotation count of the current drum cartridge has exceeded the rotation count for which high-quality
printing is guaranteed. Depending on the environment, type of paper used, and usage situation, you may
not be able to obtain high print quality for documents containing photographs or halftone patterns. Please
check the print quality, and if you are satisfied, it is not necessary to immediately replace the drum car-
tridge. However, we recommend that you occasionally check the print quality and replace the drum car-
tridge if the print quality is unacceptable, or replace the drum cartridge when you replace the toner
cartridge.
• The drum cartridge’s service life is finished. Please replace the drum cartridge when you replace the toner
cartridge. Depending on the environment, type of paper used, and usage situation, printing quality may be
affected. Please check the printing quality. We recommend that you replace the drum cartridge soon, as
necessary.
* If you continue to use the drum cartridge without replacing it, the print quality may suddenly worsen, or
the unit may malfunction.
• When performing scan to email address, the number of scanned pages or the file size of the scanned data
has exceeded the limitation. Divide the document into sections.