Installation
To mount the keypad flat against the wall, use the mounting bracket.
Note:
R
Mount the keypad on the stable location where the keypad can be adequately
supported when mounting.
R
Do not mount keypad on a soft material. It may fall down, break, or cause injury.
R
Do not mount the keypad on a plywood surface that is less than 25.4 mm
(1 inch) thick.
R
The pull-out strength of the installation area must be at least 29.4 N (3 kgf).
Determining the installation location
Note:
R
Make sure there is at least 20 cm (7 7/8 inches) of space to the left of the
keypad (when mounted) so that the buttons on the side of the keypad can be
accessed.
1
Remove the mounting bracket.
R
Place the keypad face-down on a flat surface, slide the bracket toward the
bottom of the keypad (
A
) by pushing it with your thumbs as shown (
B
),
and then lift the bracket up and away from the keypad (
C
).
B
A
C
10
For assistance, visit www.panasonic.ca/english/support
Setup
HNK101C_(en_en)_0804_ver.030.pdf 10
2015/08/04 21:00:14
