Error messages
Display message
Cause/solution
Hub no power
or
No link.
Reconnect
AC adaptor.
R
The handset has lost communication with the hub. Move
closer to the hub and try again.
R
Unplug the hub’s AC adaptor to reset the unit. Reconnect the
adaptor and try again.
R
The handset’s registration may have been cancelled.
Re-register the handset (page 31).
Cannot obtain
IP Address
R
Your wireless router does not support DHCP, or the DHCP
feature of your wireless router is turned off. If your wireless
router supports DHCP, make sure that its DHCP feature is
turned on. If DHCP is not available, set the hub’s IP settings
manually. See “Advanced configuration (static IP settings)”,
page 32.
Error
R
Recording was too short. Try again.
Failed to
connect
R
You entered the wrong password when configuring the hub to
connect to your wireless router. Confirm the password and try
again. If your wireless router is configured to use a
hexadecimal password, enter the correct password using
numbers 0-9 and letters a-f.
R
If you have configured your wireless router to use MAC
address filtering, make sure you add the hub’s MAC address
to the list of authorised MAC addresses.
IP Address
conflicts
R
The IP address assigned to the hub is also assigned to
another device on your network. Check the IP address
settings of the hub (page 32) and other devices on the
network.
You must first
subscribe
to Caller ID.
R
You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
Use
rechargeable
battery.
R
A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 3, 7.
Wrong PW
R
You entered the wrong password when configuring the hub to
connect to your wireless router. Confirm the password and try
again.
46
Useful Information
Содержание KX-HNH100FX
Страница 54: ...54 Notes ...
Страница 55: ...55 Notes ...