9. Help
41
9.3.3 Fax – sending
9.3.4 Fax – receiving
Problem
Cause & Solution
I cannot send documents.
L
The telephone line cord is connected to the
[
EXT
]
jack on the unit. Connect
to the
[
LINE
]
jack (page 4) (KX-FT932 only).
L
The other party’s fax machine is busy or has run out of recording paper. Try
again.
L
The other party does not have a fax machine. Check with the other party.
L
The other party’s fax machine failed to answer the fax automatically. Send
the fax manually (page 20).
I cannot send a fax overseas.
L
Use the overseas transmission mode of feature #23 (page 33).
L
Add two pauses at the end of the telephone number or dial manually.
The other party complains
that letters on their received
document are distorted or not
clear.
L
If your line has special telephone services such as call waiting, the service
may have been activated during fax transmission. Connect the unit to a line
that does not have these services.
L
Another telephone on the same line is off the hook. Hang up the telephone
and try again.
L
Try copying the document. If the copied image is clear, there may be
something wrong with the other party’s machine.
L
Adjust the scan contrast using feature #58 (page 34).
The other party complains
that black lines, white lines or
smudges appear on their
received document.
L
The scanner glass, white plate or rollers are dirty with correction fluid, etc.
Clean them (page 45). Please do not insert a document before correction
fluid has dried completely.
Problem
Cause & Solution
I cannot receive documents.
L
The telephone line cord is connected to the
[
EXT
]
jack on the unit. Connect
to the
[
LINE
]
jack (page 4) (KX-FT932 only).
L
The memory is full of received documents due to a lack of recording paper
or a recording paper jam. Install paper (page 5) or clear the jammed paper
(page 44).
I cannot receive documents
automatically.
L
The receiving mode is set to TEL mode.
Change the receiving mode:
–
KX-FT932: FAX ONLY mode (page 26) or TEL/FAX mode (page 25).
–
KX-FT938: TAM/FAX mode (page 25), FAX ONLY mode (page 26) or
TEL/FAX mode (page 25).
L
The time taken to answer the call is too long. Decrease the number of rings
before the unit answers a call (feature #06 on page 32).
L
The greeting message is too long. Record a shorter message (page 28)
(KX-FT938 only).
The display shows
“
CONNECTING.....
”, but
faxes are not received.
L
The receiving mode is set to FAX ONLY mode and the incoming call is not
a fax. Change the receiving mode:
–
KX-FT932: TEL mode (page 24) or TEL/FAX mode (page 25).
–
KX-FT938: TAM/FAX mode (page 25), TEL mode (page 24) or TEL/FAX
mode (page 25).
A blank sheet is ejected.
L
The recording paper is not installed correctly. Make sure that the shiny side
of the paper is facing down and re-install the paper (page 5).
L
The other party placed the document in their fax machine the wrong way.
Check with the other party.
FT932-938FX_PFQX2588ZA-en.book Page 41 Thursday, June 15, 2006 8:30 AM
Содержание KX-FT932FX
Страница 3: ...Table of Contents 3 User record 11 3 User record 48 12 Index 12 1 Index 49 ...
Страница 50: ...50 Notes ...
Страница 51: ...51 Notes ...