Preparing Documents
Acceptable Documents
The acceptable documents for this scanner are as follows.
Document size:
48–216 mm
(1.9–8.5 in.)
70–2,540 mm
(2.8–100 in.)
Paper thickness: 20–209 g/m² (5.4–55 lb.)
•
The height of all the documents on the tray should be
less than 7.5 mm (0.3 in.).
This compares to 75 sheets (80 g/m² or 20 lb.) of new
paper.
•
With the exception of ISO format cards, the minimum
guaranteed feeding length is 70 mm (2.8 in.).
•
Single paper feeding is recommended for papers
exceeding the legal size length.
•
When thin documents of 40 g/m² (10.7 lb.) or less are
scanned, we recommend that the feed speed is set to
"Slow". The feed speed can be set to "Slow" in the
TWAIN driver, the ISIS driver, or in Image Capture
Plus. For details, refer to the help of each piece of
software.
Recommended paper: Plain paper
Acceptable cards
ISO format card:
Size:
85.6 x 54 mm (3.4 x 2.1 in.)
Thickness:
0.76 mm (0.03 in.)
Embossed card is also acceptable.
•
A maximum of 3 cards can be loaded on the feed tray.
The height of the total cards (the total thickness including the embossing on each card) should be less than
5 mm (0.2 in.). Additionally, the embossing on each card must not get entangled with others.
•
Use the landscape orientation when scanning an embossed card.
If the scanning fails, place the card upside down, and then try again.
•
Use the mixed batch card guide (page 24) when scanning mixed media (cards and papers) at the
same time.
14
Operating Manual
Operation
