Panasonic KV-S1020C SERIES, Руководство по обслуживанию

Страница: 82 / 117

82
F33: USB IC
(IC1010) Error
97 00 00 00 Access error to USB Controller
(IC1010) 1. Check the soldering condition of the following parts
and of their surrounding circuit on the CONTROL
Board.
(1) USB-C (IC1010)
(2) Gate Array (IC1007)
(3) JK1001
(4) CPU (IC1016)
2. Replace faulty parts or board.
F34: EEPROM
(IC1011) Error
98 00 00 00 Access error to EEPROM (IC1011) 1. Check the soldering condition of the following part
and of their surrounding circuit on the CONTROL
Board.
(1) EEPROM (IC1011)
(2) CPU (IC1016)
2. Replace faulty parts or board.
F37: Overrun Error 9B 01 xx xx Overrun error occurred during
image scanning process 1. Confirm the firmware version.
F60: Front-side
gain adjustment
error
50 00 00 00 1. The surface of Scanning Glass
(F) is dirty. 1. Clean the surface with Roller Cleaning Paper.
2. The Scanning Glass (F) is not
attached to the scanner properly. 1. Check the condition of the glass
attachment.
2. Reattach the glass (See 8.2.7.)
3. Lamp (F) does not light or gets
dark. 1. Perform the "CCD Level" test in Sec. 9.3.6. to check
whether the Lamp (F) lights or not.
2. Check whether control signals are supplied to lamp
(F) drive circuit (Lamp Drive Board (F)), normally.
(1) Connection between CN1008 (CONTROL Board)
and Lamp Drive Board (F)
(2) Monitor the following signals, executing
"CCD
Level” test in Sec.9.3.6.
• CN1008-6th (FLAMP_ON): Approx. +3 V
• CN1008-7th: +16 V
3. Check the Lamp Drive Board (F)'s soldering condition
and the connection to the Lamp (F).
4. Check whether Lamp (F) is damaged, or broken.
5. Replace faulty parts or board.
4. Problem with Pixel data from
CCD (F) Board or from image
processing circuit 1. Check the connection and soldering condition of the
following parts.
(1) between CN2001 (CCD Board (F)) and CN1001
(CONTROL Board)
2. Check the soldering condition of the
following parts and of their surrounding circuit on the
CCD Board (F).
(1) IC2002
(2) IC2003
3. Check the soldering condition of the following parts
and of their surrounding circuit on the CONTROL
Board.
(1) IC1007 (Gate Array: especially 68th to 71st pins)
(2) IC1004, IC1005 (A/D Conv.)
4. Monitor the following CCD Timing signals on the
CN1001.
(1) FCCD_TG: See Fig. 10.1.1.
(2) FCCD_CLK1: See Fig. 10.1.2.
(3) FCCD RS: See Fig. 10.1.3.
(4) FCCD CP: See Fig. 10.1.4.
5. Replace faulty parts or boards.
Error Code Possible Cause Check Point
Classified Code ST1 ST2 ST3 ST4