7.1.1 Configure the washer settings (“Washer control” setup
menu)
Select “Washer control” for “Relay output” on the [Basic] tab of the “Basic” page. Click “Washer control >>”.
(Refer to page 42)
[Pulse width]
Enter the pulse width of the washer from 1 second to 60 seconds in 1 second intervals.
Available time setting:
1 to 60
•
Default:
5
[Wiper count]
After the time for the pulse width of the wiper has completed, specify the wiper count.
Available number of counts:
0 to 10
•
Default:
2
[Close] button
Click this button to close the “Washer control” setup menu.
Note
•
When “0” is selected for “Wiper count”, wiper control is not performed after washer control and the
camera position reverts back to the position it was before the washer operations started.
•
Refer to the Important Information for information about washer installation.
7.2 Configure the Internet settings [Internet]
Click the [Internet] tab of the “Basic” page. (
®
Operating Instructions
43
7 Configure the basic settings of the camera [Basic]
