•
Default:
8181
The following port numbers are unavailable since they are already in use.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 554, 995, 10669, 10670, 59000-61000
[Alarm deactivation time]
Configure the duration that detections won't be made after an alarm is detected. For example, by using this
function you can prevent E-mail from being sent too often when E-mail notifications are configured to be sent
to cellular phones when an alarm is detected.
5s/ 10s/ 30s/ 1min/ 3min/ 5min/ 10min
Default:
5s
Note
•
The duration that alarm detections are not made can be managed for each type of alarm. For example,
during the time when detections for command alarms are not made, detections for VMD alarm can be
made.
10.2 Configure the settings relating to the camera
action on alarm occurrence [Alarm]
Click the [Alarm] tab on the “Alarm” page. (
®
The settings related to the camera action on alarm can be configured in this section.
Camera action on alarm
[Terminal alarm 1]
Select an action to be taken when a terminal alarm 1 is detected from the following. This setting is available
when “Terminal 1” is selected for “Alarm input” of the [Alarm] tab.
•
Off:
Does not take any action even when a terminal alarm 1 is detected.
•
1-256:
If a previously registered preset position is selected, when a terminal alarm 1 is detected, the camera
will move to that position.
•
Auto track:
When a terminal alarm 1 is detected, the camera will start the auto tracking.
•
Patrol 1:
When a terminal alarm 1 is detected, the camera will start the patrol.
* If Patrol 1 is not registered it is not displayed on the screen.
•
Default:
Off
[Terminal alarm 2]
Operating Instructions
101
10 Configure the alarm settings [Alarm]
