Mounting board
Ceiling board
Mounting board
Ceiling board
2
Setting up the Mounting board.
For suspended ceilings
(1) Prepare a Mounting board long enough to
span the distance between the C-beams,
and cut a
φ
60 mm {2-3/8”} hole in it that
matches the hole in the ceiling.
(2) Use the template (provided) to cut four
φ
6
mm {1/4”} holes (in four positions) in the
mounting board.
For structurally strong ceilings
Prepare the mounting board by cutting a
φ
60
mm {2-3/8”} hole in it.
FEATURES
Ceiling Mount Bracket
Instructions
Model No.
WV-Q117A
Ns0513-3042
PGQX1355
W
A
Printed in China
C beam
M beam
60 mm in diameter
{2-3/8”}
Ceiling
1
Decide where to install the camera and open
a
φ
60 mm {2-3/8”} hole in the ceiling.
INSTALLATION
3
Attach the Ceiling Mount Ring (provided) to
the Mounting board Screws are not provided.
Align it with the position the camera will be
installed.
7
For suspended
ceilings
7
For structurally
strong ceilings
Ceiling Mount Ring
(provided)
Ceiling Mount Ring
(provided)
M4 Screws
(not provided)
Wood screws
(not provided)
Ceiling hanging bracket:
This bracket can be used to hang the camera
from a suspended ceiling or other location that is
not strong enough to hold a screw.
Before attempting to connect or install this product,
please read these instructions carefully and
save this manual for future use.
The model number is abbreviated in some descrip-
tions in this manual.
• Fasten the bracket to a ceiling strong enough
to support the camera weight (approx. 2.9 k
g
{6.38 lbs}).
• Wipe the bracket regularly using a soft and
dry cloth, or a cloth moistened with a water
solution of an ordinary kitchen detergent.
• Do not use chemicals for cleaning the enclo-
sure as it may damage the surface.
• All the necessary steps required for installing
this product must be taken by a qualified ser-
vice person or system installer.
PRECAUTIONS
• Be sure to use the aniti-fall wire.
• Do not use this bracket except with suitable
cameras.
• Follow all applicable local and national elec-
trical, fire and safety codes when installing
the camera with this ceiling mount bracket.
The model numbers in this Operating Instruc-
tions are shown without suffix.
15
°
Mounting
Screw
Rotate
Remove the Camera
Mounting Base by
pulling up.
4
Installing the Mounting board.
For suspended ceilings
Align it with the hole in the ceiling and lay it
across the two C-beams.
For structurally strong ceilings
Align it with the hole in the ceiling and attach
it.
5
Remove the Mounting Screw (M3, provided),
pull up the Camera Mounting Base off the
camera, and turn the camera counterclock-
wise.
Lock Lug
Fixing Screws
L-type Base Lug (provided)
Lock Lug
Lock Lug
Fixing Screws
6
Remove the two Lock Lug Fixing Screws and
replace the Lock Lug with L-type.
Retighten the two Lock Lug Fixing Screws
(refer to the right figure).
Recommended tightening torque: 0.68 N
·
m
{0.51 lbf
·
ft}
̲PGQX1355YA.qxd 17.1.10 3:04 PM ページ 1
