Using registration buttons
1
Access point:
Press and hold
M
SETUP
N
until
the LED indicator blinks slowly
in green.
2
Camera:
Press and hold the
registration button until the
LED indicator blinks slowly in
green.
R
When registration is
completed, the camera
sounds one long beep.
Note:
R
If registration fails, the camera
sounds several short beeps.
Using the app
When you register the camera by
using the
[HomeHawk]
app, you
can assign a name to your
devices. For more information,
refer to the User’s Guide.
Installation
Installation precautions
R
Do not use an impact driver.
(This may lead to damaged
screws or over-tightening.)
R
Mount the camera on the stable
location with a height of 2.2 m
(7 feet 3 inches) where the unit
can be adequately supported
when installing.
R
Do not mount the camera on a
soft material. It may fall down,
break or cause injury.
Installing the camera
1
Open the interface cover (
A
),
then slide the power switch
(
B
) to on.
2
Secure the screw safety wire
to the screw hole (
C
) of the
camera using a driver, and
then pass the wire through the
ring of the screw safety wire
(
D
).
3
4
1
2
For assistance, please visit http://shop.panasonic.com/support
13
Setup
HNC710̲(en̲en)̲1227̲ver.010.pdf 13
2017/12/27 15:55:03
