126
LSQT1093
Others
≥
If there is dust, a scratch, or dirt on disc or if
it is warped, the following phenomena may
occur:
– Block noise in playback image
– Momentary stop of playback image
– Sound interrupted during playback, or
abnormal sound
– [
] appears for thumbnail displays
– Disc cannot correctly be recognized
– Delay between video and audio
When the ACCESS/PC lamp is illuminated
(during access to the disc), do not open the
disc cover, turn off the power, or cause any
vibrations or impacts.
DVD-R/DVD-R DL
≥
For optimum recording on DVD-R or DVD-R DL
discs, this unit writes control data to a DVD-R
or DVD-R DL used for recording when it is
being inserted and ejected. If the disc has no
area for control data to be written, recording
may not be possible. To prevent this, do not
insert a DVD-R or DVD-R DL which has been
recorded on more than 50 times.
≥
Do not insert a DVD-R or DVD-R DL recorded
on this unit that has not been finalized into a
recordable device, such as a DVD recorder.
The recorded data may be damaged.
≥
The memory capacity indicated on the label of
an SD card is the total of the capacity for
copyright protection and management and the
capacity which can be used on the unit, a
computer etc.
≥
During prolonged use, the unit’s surfaces and
the SD card will heat up slightly. This is normal.
Always set the mode dial to OFF when
inserting or removing an SD card.
While this unit accesses the SD card (while
or
is being displayed/the access lamp
is lit), do not remove the SD card, operate the
mode dial, turn off the power or shake or
impact the unit.
ª
About the miniSD Card
≥
Be sure to insert miniSD Cards in the dedicated
card adaptor before use. Inserting a card in this
unit without the adaptor may damage the unit
or the card.
≥
Do not insert an empty card adaptor in this unit.
Do not leave the adaptor in this unit while
inserting or removing miniSD Cards. This may
cause the unit to malfunction.
≥
When the LCD monitor gets dirty, wipe it with a
dry soft cloth.
≥
In a place with drastic temperature changes,
condensation may form on the LCD monitor.
Wipe it with soft dry cloth.
≥
When the unit has become very cold, for
example due to storage in a cold area, its LCD
monitor will be slightly darker than usual
immediately after the power is turned on. The
normal brightness will be restored when the
unit’s internal temperature rises.
About the disc
About the SD card
LCD monitor/viewfinder
Extremely high precision technology is
employed to produce the LCD Monitor screen
featuring a total of approximately
251,000 pixels. The result is more than
99.99% effective pixels with a mere 0.01% of
the pixels inactive or always lit. However, this
is not a malfunction and does not affect the
recorded picture.
Extremely high precision technology is
employed to produce the viewfinder screen
featuring a total of approximately
183,000 pixels. The result is more than
99.99% effective pixels with a mere 0.01% of
the pixels inactive or always lit. However, this
is not a malfunction and does not affect the
recorded picture.
LSQT1093ENG.book 126 ページ ２００７年１月１５日 月曜日 午前９時２３分
