Others
119
LSQT1093
Problem
Check points
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
≥
The unit cannot be operated unless you open the LCD monitor or
extend the viewfinder.
≥
Press the RESET button. (
l
122) If normal conditions are not
restored yet, remove the battery or AC adaptor, wait about 1 minute
and then reconnect the battery or AC adaptor. Then about 1 minute
later, turn on the power again. (Conducting the above operation
when the access lamp is on may destroy the data on the disc or SD
card.)
The remote control does
not function.
≥
Has the button-type battery of the remote control run out?
#
Replace it with a new button-type battery. (
l
24)
The DISC EJECT lever
does not work.
≥
The disc cover will not open unless the unit is powered.
#
Connect a charged battery or AC adaptor.
≥
The DISC EJECT lever does not work when the unit is connected to
the computer.
#
Disconnect the USB cable.
The screen has changed
suddenly.
≥
Has the demonstration started?
#
If you set [DEMO MODE] to [ON] without inserting a disc or an
SD card in recording mode, the unit is automatically set to the
demonstration mode for introducing its functions. Normally this
should be set to [OFF]. Press the MENU button, then select
[SETUP]
#
[DEMO MODE]
#
[OFF] and press the cursor
button.
A function indication
such as the remaining
time indication or the
elapsed time indication is
not shown.
≥
If you set [SETUP]
>
[DISPLAY]
>
[OFF], indications other than
warnings and date indications disappear.
The disc cannot be read.
≥
Are there fingerprints or dirt on the surface of the disc?
#
If there are fingerprints or dirt on the disc, wipe them off. (
l
30)
Recording does not start
although power is
supplied to this unit and
the disc or SD card is
correctly inserted.
≥
Has the DVD-RW, DVD-R or DVD-R DL been finalized?
#
After finalizing, the discs become play-only and cannot record. If
you un-finalize a DVD-RW, it can be used for recording. (
l
87)
≥
Has the SD card’s write protect switch been set to LOCK?
#
No recording is possible while the write protect switch is set to
LOCK. (
l
29)
≥
Is the memory of the disc or SD card full?
#
If the disc or SD card has no more available memory, free up
some memory by deleting unnecessary scenes (
l
80, 82) or
use a new disc or SD card.
≥
Is the unit set to the recording mode?
#
No recording is possible unless the mode dial is at
.
≥
Is the disc cover open?
#
If the cover is open, this unit may not operate normally. Close the
disc cover.
LSQT1093ENG.book 119 ページ ２００７年１月１５日 月曜日 午前９時２３分
