Panasonic GM1 Series, Справочное руководство

Страница: 31 / 98

4.2 Setting Parameters and Performing I/O Mapping
● Specify operations of analog input units and analog output units by setting parameters.
● Perform the following using I/O mapping.
• You can create variables for each channel and use them in the control program.
• Map them to existing variables so that variables correspond to channels.
■
Overview
● After adding analog I/O units to the project, select them from the device pane to change its
parameters and to perform I/O.
● The analog I/O units are displayed as follows in the device pane.
• The segments indicated by * differ according to the expansion location.
Analog input unit Slot*_Analog_8IN (AGM1AD8)
Analog output unit Slot*_Analog_4OUT (AGM1DA4)
Setting parameters of the analog input unit connected to the 1st unit
1.
Double-click "Slot1_Analog_8IN(AGM1AD8)" in the device pane.
2.
Click the "Analog_8IN Parameters" tab.
3.
Set parameters for each channel.
Parameter setting example
(Note 1) In this example, the analog input range for channel 3 is set to "0 to 20 mA".
4.
Click the "Analog_8IN I/O Mapping" tab.
5.
Individually map variables that can be used for the program to the channel to be used.
4.2 Setting Parameters and Performing I/O Mapping
WUME-GM1AIO-01 4-5