Panasonic FP2 Positioning Unit RTEX, Техническое руководство

Страница: 82 / 288

7-30
7.12
45B
Customizing Software
Changing Column Width
Widen the column width to enable all the characters to be shown during data editing, or narrow it when
the resolution of the PC you use is small. As the column width is saved when this software quits, the
same width will be recreated at the next time of the start-up.
1. The mouse cursor changes to a mark like “+” by moving the mouse cursor to the right end of
the column you want to widen the width in the header on the upper corner of the data editing
screen.
2. Move the cursor left and right with clicking down the left button of the mouse.
3. Release the left button of the mouse to finish the change in the column width.
Key Point:
The column width returns to the one on start-up by double-clicking the mouse in the state of the above
procedure 1.
- Showing/Hiding Toolbar
Set to show or hide the toolbar.
Select [View] → [Toolbar], and check or uncheck in the menu.
The toolbar is indicated with the check, and it is not indicated without the check.
- Showing/Hiding Status Bar
Set to show or hide the status bar.
Select [View] → [Status Bar], and check or uncheck in the menu.
The status bar is indicated with the check, and it is not indicated without the check.
- Showing/Hiding Parameter-Status Bar
Set to show or hide the parameter-status bar.
Select [View] → [Parameter-Status Bar], and check or uncheck in the menu.
The parameter-status bar is indicated with the check, and it is not indicated without the check.
- Showing/Hiding Guidance Bar
Set to show or hide the guidance bar on the main screen that provides guidance on various settings.
Select [View] → [Guidance Bar], and check or uncheck in the menu.
The guidance bar is indicated with the check, and it is not indicated without the check.
- Configuration setting
Select [Option] → [Configuration] in the menu bar. The following dialog is shown.
The current folder in the setting data file can be changed.
Current folder Specify a current folder to be used for this software.
Tool operation monitoring time Set the communication error detection time in the Tool operation.