Panasonic FP2 ET-LAN, Техническое руководство

Страница: 166 / 306

10-24
10.2.3 System Connection Information Setting
-
Necessary data is set for the system connection information setting items using the dedicated setup
tool (Configurator ET).
- For the connection to be used, set the connection information settings as shown below. (Settings for up
to 3 connections can be conducted.)
System connection information setting item
Name Setting value Description Default value
System
connection
information
settings 1 to
3
A
ppl
ic
at
ion bei
ng us
ed
Communication
method
Specify whether “TCP/IP” is used or
“UDP/IP” is used for the currently-set
communication method.
TCP/IP
Open method This is valid only when “TCP/IP” is specified
for the communication method.
Select “Fullpassive” or “Unpassive.” Unpassive
Application in which
connection is used Only “MEWTOCOL communication” can be
used. MEWTOCOL
communication
Source node port No. Specify any port number other than “0”..
(A value of “8000” or higher is
recommended.)
System connection 1
port 8500
System connection 2
port 8501
System connection 3
port 8502
Destination node IP
address
<When using TCP Fullpassive open>
Specify an IP address for the destination
node that is in the same class, and is other
than “0” and “255.255.255.255”.
<When using UDP>
Specify the IP address for the destination
node that is in the same class, and is other
than “0H”.
<When using TCP Unpassive>
No address needs to be specified.
0.0.0.0
Destination node port No.
Specify the port number other than “0”.
(A value of “8000” or higher is
recommended.)
<When using TCP Unpassive>
No address needs to be specified.
0
Destination node
MEWTOCOL station No.
▪
Specify the station number of the
destination node when MEWTOCOL
communication is used.
Values 1 to 64 can be selected.
▪
Avoid duplicating the number of another
station on the network.
0
Destination node Ethernet
address Not used.
00-00-00-00
Connection closing time
(min.) When no communication is performed by the
partner within the time specified here, the
connection is closed.
When the set value is “0”. the connection is
not closed.
0
Note:
-
System connection can be set only with the setup tool (Configurator ET). Even if the ladder program is
used, settings cannot be performed.
-
System connection can be used when the auto connection function is available. (Mode setting switch 2
is ON).
-
System connection automatically executes re-open processing when the connection is closed from the
partner, and goes into the ready status to open the connection.
-
The number noted above is indicated in decimal number. For the hexadecimal numbers, “H” is added
after the number.