Panasonic FP2 ET-LAN, Техническое руководство

Страница: 150 / 306

10-8
10.1.4 Auto Connection Information Settings
-
Necessary data is set for the auto connection information setting items using the dedicated setup tool
(Configurator ET).
- For the connection to be used, set the connection information settings as shown below. (Settings for up
to 8 connections can be conducted.)
- Auto connection information setting item
Name Setting value Description Default
Connection
information
settings
1 to 8
Connection
valid/invalid
selection For the current connection settings, “Valid” or “Invalid” can be
selected. When “Invalid” is selected, the open processing is not
performed in the connection. Invalid
A
ppl
ic
a
ti
on bei
ng
us
ed
Communica
-tion method Specify whether “TCP/IP” is used or “UDP/IP” is used for the
currently-set communication method. TCP/IP
Open
method This is valid only when “TCP/IP” is specified for the
communication method.
Select one method among the followings;
“Active,” “Fullpassive,” or “Unpassive.” Active
Application
in which
connection
is used When using computer link or data transfer, select “MEWTOCOL
communication.”
When using transparent communication, select “Transparent
communication.” MEWTOCOL
communication
Source node
port No. Specify any port number other than “0”.
(A value of 8000 (1F40H) or higher is recommended.) 0
Destination
node IP address
<When using TCP Fullpassive and Active open>
Specify an IP address for the destination node that is in the
same class, and is other than 0.0.0.0 or 255.255.255.255.
<When using UDP>
Specify an IP address for the destination node that is in the
same class, and is other than 0.0.0.0.
<When using TCP Unpassive>
No address needs to be specified. 0
Destination
node
port No. Specify any port number other than 0.
(A value of 8000 (1F40H) or higher is recommended.)
<When using TCP Unpassive>
No address needs to be specified. 0
Destination
node
MEWTOCOL
station No.
Specify the station number of the destination node
when MEWTOCOL communication is performed.
▪
Setting range: 1 to 64
▪
Avoid duplicating the number of another station on the
network.
▪
This is ignored when MEWTOCOL communication is not used.
0
Destination
node Ethernet
address Specify this address if the destination node has no ARP
functions under the condition that TCP Active open is used. 00-00-00-00
Connection
closing time
(min.) When no communication is performed by the partner within the
time specified here, the connection is closed.
When the set value is “0,” the connection is not closed. 0
Number of re-
open times
Specify the number of times that re-open is to be conducted.
After the specified times are satisfied, an error is issued. A
connector in which the error is issued cannot be used.
Users can select the number of re-open times from among 0 to
254 or infinite number of times.
When the set value is “0,” re-open is not performed.
When the set value is 255 or higher, re-open is performed
infinitely.
0
Note: 1. Open method: When “Active” is selected, re-open is performed every 5 to 10 seconds.
2. The number noted above is indicated in decimal number. For the hexadecimal numbers,
“H” is added after the number.
Reference: For details on each setting, refer to Chapter 6 “Open Processing and Close
Processing”