- 10 -
CAUTION:
• To prevent excessive temperature
increase of the tool surface, do not
operate the tool continuously using
two or more battery packs. The tool
needs cool-off time before switching
to another pack.
• Do not close up vent holes on the
sides of the body during operation.
Otherwise, the machine function is
adversely affected to cause a failure.
• Do NOT strain the tool (motor). This
may cause damage to the unit.
• Use the tool in such a way as to
prevent the air from the body vent
holes from blowing directly onto
your skin. Otherwise, you may get
burned.
Bit-locking Function
1. With the trigger switch not engaged
and a screwdriver bit locked in
place, the tool can be used as a
manual screwdriver (up to 40 N•m,
408 k
g
f-cm, 353 in-lbs).
There will be a little play in the
chuck, but this is not a malfunction.
2.
This feature is handy for tightening
screws that require more torque
than the maximum torque of the
driver (position on the clutch), for
confirming the tightness of a screw or
to loosen an extremely tight screw.
Control Panel
(1)
(2)
(3)
(1) LED light
Before the use of LED
light, always pull the
power switch once.
Press the LED light
button.
The light illuminates with
very low current, and it
does not adversely af-
fect the performance of
the tool during use or its
battery capacity.
CAUTION:
• The built-in LED light is designed
to illuminate the small work area
tempo-rarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
• LED light turns off when the tool has
not been used for 5 minutes.
This product has the built-in LED light.
This product is classified into “Class 1 LED
Product” to IEC (EN) 60825-1:2001.
Class 1 LED Product
Caution:
DO NOT STARE INTO BEAM.
Use of controls or adjustments or perfor-
mance of procedures other than those
specified herein may result in hazardous
radiation exposure.
(2) Overheat warning lamp
Off
(normal
operation)
Flashing:
Overheat
(battery)
Indicates operation has
been halted due to motor
or battery overheating.
To protect the motor or battery, be
sure to note the following when carry-
ing out this operation.
01_EN_EY7442_7450_7950(UL).indd 10
2011-3-1 10:22:23
