How to Use
Massage
head
Tapping
action
EN27
●
Keep your head on the pillow until
the soft tapping action begins. Lifting
your head from the pillow will result in
incorrect determination of the shoulder
position.
●
If you press
while the tapping action is still going on, it will end the body scanning and the
massage will start.
●
The leg rest may adjust automatically so that the soles of the feet touch the sole massage
section according to your estimated height based on the shoulder position.
●
If the shoulder position is off drastically, turn the power off once, and repeat from step
❶
with
shoulder firmly pressed against the backrest.
Approximately 30 seconds after the body scanning starts, the
massage heads slowly lower to the shoulder position, and a
soft tapping action begins to determine your shoulder position.
A single press of the
button will raise or lower
the massage heads
approximately 1.2 cm
(0.5 in.).
Too high
Correct position of the
massage head
(The point where the
tapping action should
be felt.)
Too low
Body scanning is completed when the tapping action finishes.
To adjust the shoulder position during the tapping action
●
When the shoulder position is incorrect, adjust then shoulder position while the soft tapping
action is in progress (for approximately 12 seconds), and use the POSITION button to move
the massage heads up or down and then press
.
●
Air in the seat will operate so the body will not
shift during the body scanning.
▶
Continued on the next page
